R21xx-HP FlexFabric 11900 ACL and QoS Configuration Guide

6
Ste
p
Command Remarks
6. (Optional.) Add or edit a rule
comment.
rule rule-id comment text
By default, no rule comments are
configured.
Configuring an advanced ACL
This section describes procedures for configuring IPv4 and IPv6 advanced ACLs.
Configuring an IPv4 advanced ACL
IPv4 advanced ACLs match packets based on source IP addresses, destination IP addresses, packet
priorities, protocols over IP, and other protocol header information, such as TCP/UDP source and
destination port numbers, TCP flags, ICMP message types, and ICMP message codes.
Compared to IPv4 basic ACLs, IPv4 advanced ACLs allow more flexible and accurate filtering.
To configure an IPv4 advanced ACL:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an IPv4 advanced ACL
and enter its view.
acl number acl-number [ name
acl-name ] [ match-order { auto |
config } ]
By default, no ACL exists.
IPv4 advanced ACLs are
numbered in the range of 3000 to
3999.
You can use the acl name acl-name
command to enter the view of a
named ACL.
3. (Optional.) Configure a
description for the IPv4
advanced ACL.
description text
By default, an IPv4 advanced ACL
has no ACL description.
4. (Optional.) Set the rule
numbering step.
step step-value The default setting is 5.