R21xx-HP FlexFabric 11900 ACL and QoS Configuration Guide

39
Ste
p
Command Remarks
6. Configure a traffic
policing action.
car cir committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size ] ] [ pir
peak-information-rate ] [ green action |
red action | yellow action ] *
By default, no traffic policing action is
configured.
On the Switch Series, the granularity of
traffic policing is 8 kbps.
7. Return to system view.
quit N/A
8. Create a QoS policy
and enter QoS policy
view.
qos policy policy-name
By default, no QoS policy is
configured.
9. Associate the traffic
class with the traffic
behavior in the QoS
policy.
classifier classifier-name behavior
behavior-name
By default, a traffic class is not
associated with a traffic behavior.
10. Return to system view.
quit N/A
11. Apply the QoS policy.
• Applying the QoS policy to an
interface
• Applying the QoS policy to a VLAN
• Applying the QoS policy globally
• Applying the QoS policy to the
control plane
Choose one of the application
destinations as needed.
By default, a QoS policy is not
applied.
12. (Optional.) Display
traffic policing
configuration
information.
display traffic behavior user-defined
[ behavior-name ]
Available in any view.
Configuring GTS
The switch supports configuring queue-based GTS by using the non-MQC approach. In queue-based
GTS, you set GTS parameters for packets of a specific queue.
To configure GTS:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Configure GTS for a
queue.
qos gts queue queue-number cir
committed-information-rate [ cbs
committed-burst-size ]
By default, GTS is not configured
on an interface.
On the Switch Series, the
granularity of GTS is 8 kbps.
Configuring the rate limit
The rate limit of a physical interface specifies the maximum rate of incoming packets or outgoing packets.
To configure the rate limit: