R21xx-HP FlexFabric 11900 EVB Command Reference

VDP resource-wait-dela

onent

Calculated value (seconds)

Result value (seconds)

26 671.08864 672

27 1342.17728 1343

28 2684.35456 2685

29 5368.70912 5369

30 10737.41824 10738

31 21474.83648 21475

Examples

# Configure the VDP resource-wait-delay exponent for Ten-GigabitEthernet 1/0/1 as 23.

<Sysname> system-view

[Sysname] interface ten-gigabitethernet 1/0/1

[Sysname-Ten-GigabitEthernet1/0/1] evb vdp timer resource-wait-delay exponent 23

evb vsi

Use evb vsi to create a VSI.

Use undo evb vsi to remove a VSI.

Syntax

evb vsi vsi-local-id { association | pre-association }

undo evb vsi vsi-local-id

Default

No VSI exists on an S-channel.

Views

S-channel interface view

Predefined user roles

network-admin

Parameters

vsi-local-id: Specifies a VSI local ID in the range of 0 to 1023.

association: Specifies the association property. On a VSI with the association property, all filters

immediately take effect.

pre-association: Specifies the pre-association property. On a VSI with the pre-association property,

VLAN filters take effect, but <VLAN, MAC> filters are not effective.

Usage guidelines

• A VSI is usually created or deleted by a VSI manager. You can also manually create or delete a VSI,

or modify its pre-association or association property by executing this command.

• A VSI is a subinterface of an S-channel interface. Removing an S-channel also removes all its VSIs.

• When you change association to pre-association for a VSI, if MAC address information is

contained in the traffic sent by a VM, the MAC address is removed from the drive on the EVB bridge,