R21xx-HP FlexFabric 11900 EVB Configuration Guide

8
• When a filter configured on a VSI contains information about a VLAN, you cannot configure the
filter on the same VSI again or on other VSIs of the S-channel interface to which the VSI belongs.
Otherwise, the system prompts an error.
• If the VSI filter is a set of VID values, and the MAC address learning function for the corresponding
S-channel is disabled, traffic for the VSI cannot be forwarded.
• Activate a VSI after configuring a VSI filter, and deactivate a VSI before removing a VSI filter.
To configure a VSI filter for a VSI:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter VSI view.
interface s-channel
interface-number:channel-id.vsi-loc
al-id
N/A
3. Configure a VSI filter.
evb vsi filter vlan vlan-id [ mac
mac-address ]
By default, no VSI filter is
configured.
Activating a VSI
Configurations such as traffic policing for a VSI (see ACL and QoS Configuration Guide) take effect only
after the VSI is activated. When a VSI is not activated, do not make any configuration except for VSI filter
configuration for the VSI.
To activate a VSI, you must first configure a VSI filter for it. To remove a VSI filter for a VSI, you must first
deactivate the VSI.
To activate a VSI:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VSI view.
interface s-channel
interface-number:channel-id.vsi-lo
cal-id
N/A
3. Activate the VSI. evb vsi active By default, no VSI is activated.
4. (Optional.) Configure a
description for the VSI.
description text
The default description information is
"interface name Interface".
Displaying and maintaining EVB
Execute display commands in any view and the reset command in user view.
Task Command
Display CDCP negotiation
information.
display evb cdcp [ interface interface-type interface-number ]
Display S-channel EVB TLV
negotiation information.
display evb evb-tlv [ interface interface-type interface-number ]
Display S-channel information. display evb s-channel [ interface interface-type interface-number ]