R21xx-HP FlexFabric 11900 EVB Configuration Guide

# Enable LLDP on EVB bridge 1 globally. Enable LLDP on Ten-GigabitEthernet 1/0/1, and

configure the Nearest non-TPMR Bridge agent for LLDP to operate in TxRx mode.

[EVB_bridge1] lldp global enable

[EVB_bridge1] interface ten-gigabitethernet 1/0/1

[EVB_bridge1-Ten-GigabitEthernet1/0/1] lldp enable

[EVB_bridge1-Ten-GigabitEthernet1/0/1] lldp agent nearest-nontpmr admin-status txrx

[EVB_bridge1-Ten-GigabitEthernet1/0/1] quit

Configure other EVB bridges in the same way. Details are not shown.

2. Verify the configuration:

a. View CDCP information. Assume that each EVB station requires two S-channels.

# Display CDCP information on EVB bridge 1.

[EVB_bridge1] display evb cdcp

---------------------------Ten-GigabitEthernet1/0/1---------------------

S-component capability : Local-supported/Remote-supported

Supported S-Channel numbers per-port : Local-167/Remote-3

SVID range : 2-4094

SCID requested from remote :

1, 2, 3

SCID/SVID pair list allocated :

<1, 1>, <2, 2>, <3, 3>

The output shows that the EVB station has established two S-channels 2 and 3. S-channel 1 is

the default S-channel.

# Display brief S-channel information on EVB bridge 1.

[EVB_bridge1] display interface s-channel brief

The brief information of interface(s) under bridge mode:

Link: ADM - administratively down; Stby - standby

Speed or Duplex: (a)/A - auto; H - half; F - full

Type: A - access; T - trunk; H - hybrid

Interface Link Speed Duplex Type PVID Description

SCH1/1:1 UP auto A T 1

SCH1/1:2 UP auto A T 1

SCH1/1:3 UP auto A T 1

The output shows that the corresponding S-channel interfaces have been created.

b. Verify the VSI creation.

# Display EVB summary on EVB bridge 1.

[EVB_bridge1] display evb summary

Default manager ID: Not configured

Port number: Not configured

Interface S-Channel number VSI number

XGE1/0/1 3 0

The output shows that no VSI exists before the EVB station sends VDP packets to the EVB

bridge.

[EVB_bridge1] display evb summary

Default manager ID: Not configured

Port number: Not configured

Interface S-Channel number VSI number