R21xx-HP FlexFabric 11900 FCoE Configuration Guide

Configuration procedure

This section describes the configurations for VFC interfaces and FIP on the FCF switch.

1. Configure Switch A:

# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A.

(Skip this step if the switch is operating in advanced mode.)

<SwitchA> system-view

[SwitchA] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Create VSAN 10 and configure Switch A to operate in FCF mode.

<SwitchA> system-view

[SwitchA] fcoe-mode fcf

[SwitchA] vsan 10

[SwitchA-vsan10] quit

# Create interface VFC 1, bind it to interface Ten-GigabitEthernet 1/0/1, and assign it to VSAN

10 as a trunk port.

[SwitchA] interface vfc 1

[SwitchA-Vfc1] bind interface ten-gigabitethernet1/0/1

[SwitchA-Vfc1] port trunk vsan 10

[SwitchA-Vfc1] quit

# Create interface VFC 2, configure it to operate in E mode, bind it to interface

Ten-GigabitEthernet 1/0/2, and assign it to VSAN 10 as a trunk port.

[SwitchA] interface vfc 2

[SwitchA-Vfc2] fc mode e

[SwitchA-Vfc2] bind interface ten-gigabitethernet1/0/2

[SwitchA-Vfc2] port trunk vsan 10

[SwitchA-Vfc2] quit

# Configure interface Ten-GigabitEthernet 1/0/1 to allow VLAN 20.

[SwitchA] interface ten-gigabitethernet1/0/1

[SwitchA-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchA-Ten-GigabitEthernet1/0/1] port trunk permit vlan 20

[SwitchA-Ten-GigabitEthernet1/0/1] quit

# Configure interface Ten-GigabitEthernet 1/0/2 to allow VLAN 20.

[SwitchA] interface ten-gigabitethernet1/0/2

[SwitchA-Ten-GigabitEthernet1/0/2] port link-type trunk

[SwitchA-Ten-GigabitEthernet1/0/2] port trunk permit vlan 20

[SwitchA-Ten-GigabitEthernet1/0/2] quit

# Enable FCoE for VLAN 20 and map it to VSAN 10.

[SwitchA] vlan 20

[SwitchA-vlan20] fcoe enable vsan 10

2. Configure Switch B:

# Configure Switch B to operate in advanced mode, save the configuration, and reboot Switch B.

(Skip this step if the switch is operating in advanced mode.)

<SwitchB> system-view