R21xx-HP FlexFabric 11900 FCoE Configuration Guide

[SwitchB] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Create VSAN 10 and configure Switch B to operate in FCF mode.

<SwitchB> system-view

[SwitchB] fcoe-mode fcf

[SwitchB] vsan 10

[SwitchB-vsan10] quit

# Create interface VFC 1, configure it to operate in E mode, bind it to interface

Ten-GigabitEthernet 1/0/2, and assign it to VSAN 10 as a trunk port.

[SwitchB] interface vfc 1

[SwitchB-Vfc1] fc mode e

[SwitchB-Vfc1] bind interface ten-gigabitethernet1/0/2

[SwitchB-Vfc1] port trunk vsan 10

[SwitchB-Vfc1] quit

# Configure interface Ten-GigabitEthernet 1/0/2 to allow VLAN 20.

[SwitchB] interface ten-gigabitethernet1/0/2

[SwitchB-Ten-GigabitEthernet1/0/2] port link-type trunk

[SwitchB-Ten-GigabitEthernet1/0/2] port trunk permit vlan 20

[SwitchB-Ten-GigabitEthernet1/0/2] quit

# Enable FCoE for VLAN 20 and map it to VSAN 10.

[SwitchB] vlan 20

[SwitchB-vlan20] fcoe enable vsan 10