R21xx-HP FlexFabric 11900 FCoE Configuration Guide

Non-disruptive reconfiguration or isolating the switch may be performed. Continu

e? [Y/N]:y

[SwitchA-vsan1] quit

# Create interface VFC 200, configure it to operate in E mode, bind it to interface

Ten-GigabitEthernet 1/0/1, and assign it to VSAN 1 as a trunk port.

[SwitchA] interface vfc 200

[SwitchA-Vfc200] fc mode e

[SwitchA-Vfc200] bind interface ten-gigabitethernet1/0/1

[SwitchA-Vfc200] port trunk vsan 1

[SwitchA-Vfc200] quit

# Configure interface Ten-GigabitEthernet 1/0/1 to allow VLAN 20.

[SwitchA] vlan 20

[SwitchA-Vlan20] quit

[SwitchA] interface ten-gigabitethernet1/0/1

[SwitchA-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchA-Ten-GigabitEthernet1/0/1] port trunk permit vlan 20

[SwitchA-Ten-GigabitEthernet1/0/1] quit

# Create interface VFC 100, configure it to operate in F mode, bind it to interface

Ten-GigabitEthernet 1/0/2, and assign it to VSAN 1 as a trunk port.

[SwitchA] interface vfc 100

[SwitchA-Vfc100] fc mode f

[SwitchA-Vfc100] bind interface ten-gigabitethernet1/0/2

[SwitchA-Vfc100] port trunk vsan 1

[SwitchA-Vfc100] quit

# Configure interface Ten-GigabitEthernet 1/0/2 to allow VLAN 20.

[SwitchA] vlan 20

[SwitchA-Vlan20] quit

[SwitchA] interface ten-gigabitethernet1/0/2

[SwitchA-Ten-GigabitEthernet1/0/2] port link-type trunk

[SwitchA-Ten-GigabitEthernet1/0/2] port trunk permit vlan 20

[SwitchA-Ten-GigabitEthernet1/0/2] quit

# Enable FCoE for VLAN 20 and map it to VSAN 1.

[SwitchA] vlan 20

[SwitchA-vlan20] fcoe enable vsan 1

2. Configure Switch B:

# Configure Switch B to operate in advanced mode, save the configuration, and reboot Switch B.

(Skip this step if the switch is operating in advanced mode.)

<SwitchB> system-view

[SwitchB] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Disable the fabric configuration function and configure Switch B to operate in FCF mode.

<SwitchB> system-view

[SwitchB] fcoe-mode fcf

[SwitchB] vsan 1

[SwitchB-vsan1] undo domain configure enable