R21xx-HP FlexFabric 11900 FCoE Configuration Guide

# Configure a name for the fabric.

[SwitchA-vsan1] fabric-name 11:11:11:11:11:11:11:11

# Configure the domain ID as 2.

[SwitchB-vsan1] domain-id 2 static

Non-disruptive reconfiguration or isolating the switch may be performed. Continu

e? [Y/N]:y

[SwitchB-vsan1] quit

# Create interface VFC 200, configure it to operate in E mode, bind it to interface

Ten-GigabitEthernet 1/0/1, and assign it to VSAN 1 as a trunk port.

[SwitchB] interface vfc 200

[SwitchB-Vfc200] fc mode e

[SwitchB-Vfc200] bind interface ten-gigabitethernet1/0/1

[SwitchB-Vfc200] port trunk vsan 1

[SwitchB-Vfc200] quit

# Configure interface Ten-GigabitEthernet 1/0/1 to allow VLAN 20.

[SwitchB] vlan 20

[SwitchB-Vlan20] quit

[SwitchB] interface ten-gigabitethernet1/0/1

[SwitchB-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchB-Ten-GigabitEthernet1/0/1] port trunk permit vlan 20

[SwitchB-Ten-GigabitEthernet1/0/1] quit

# Create interface VFC 100, configure it to operate in F mode, bind it to interface

Ten-GigabitEthernet 1/0/2, and assign it to VSAN 1 as a trunk port.

[SwitchB] interface vfc 100

[SwitchB-Vfc100] fc mode f

[SwitchB-Vfc100] bind interface ten-gigabitethernet1/0/2

[SwitchB-Vfc100] port trunk vsan 1

[SwitchB-Vfc100] quit

# Configure interface Ten-GigabitEthernet 1/0/2 to allow VLAN 20.

[SwitchB] vlan 20

[SwitchB-Vlan20] quit

[SwitchB] interface ten-gigabitethernet1/0/2

[SwitchB-Ten-GigabitEthernet1/0/2] port link-type trunk

[SwitchB-Ten-GigabitEthernet1/0/2] port trunk permit vlan 20

[SwitchB-Ten-GigabitEthernet1/0/2] quit

# Enable FCoE for VLAN 20 and map it to VSAN 1.

[SwitchB] vlan 20

[SwitchB-vlan20] fcoe enable vsan 1

Verifying the configurations

1. Verify the configurations on Switch A.

[SwitchA-vsan1] display fc domain vsan 1

Domain Information of VSAN 1:

Running time information:

State: Stable