R21xx-HP FlexFabric 11900 FCoE Configuration Guide

[SwitchD] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Enable the fabric configuration function (optional, because this function is enabled by default),

and configure Switch D to operate in FCF mode.

<SwitchD> system-view

[SwitchD] fcoe-mode fcf

[SwitchD] vsan 1

[SwitchD-vsan1] domain configure enable

# Configure the domain ID as 14.

[SwitchD-vsan1] domain-id 14 preferred

Non-disruptive reconfiguration or isolating the switch may be performed. Continu

e? [Y/N]:y

[SwitchD-vsan1] quit

# Enable FCoE for VLAN 10 and map it to VSAN 1.

[SwitchD] vlan 10

[SwitchD-vlan10] fcoe enable vsan 1

[SwitchD-vlan10] quit

# Create interface VFC 1, bind it to interface Ten-GigabitEthernet 4/0/1, configure it to operate

in F mode, and assign it to VSAN 1 as a trunk port.

[SwitchD] interface Vfc 1

[SwitchD-Vfc1] bind interface ten-gigabitethernet4/0/1

[SwitchD-Vfc1] fc mode f

[SwitchD-Vfc1] port trunk vsan 1

[SwitchD-Vfc1] quit

# Create interface VFC 2, bind it to interface Ten-GigabitEthernet 4/0/2, configure it to operate

in E mode, and assign it to VSAN 1 as a trunk port.

[SwitchD] interface Vfc 2

[SwitchD-Vfc2] bind interface ten-gigabitethernet4/0/2

[SwitchD-Vfc2] fc mode e

[SwitchD-Vfc2] port trunk vsan 1

[SwitchD-Vfc2] quit

Verifying the configurations

1. Verify the configurations on Switch A:

# Display the domain information of VSAN 1.

[SwitchA-vsan1] display fc domain vsan 1

Domain Information of VSAN 1:

Running time information:

State: Stable

Switch WWN: 48:33:43:2d:46:43:1A:1A

Fabric name: 48:33:43:2d:46:43:1B:1B

Priority: 128

Domain ID: 11

Configuration information: