R21xx-HP FlexFabric 11900 FCoE Configuration Guide

Figure 18 Network diagram

Configuration procedure

1. Configure Switch A:

# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A.

(Skip this step if the switch is operating in advanced mode.)

<SwitchA> system-view

[SwitchA] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Configure Switch A to operate in FCF mode and bind interface VFC 100 to interface

Ten-GigabitEthernet 1/0/1.

<SwitchA> system-view

[SwitchA] fcoe-mode fcf

[SwitchA] interface Vfc 100

[SwitchA-Vfc100] bind interface Ten-GigabitEthernet1/0/1

# Configure interface VFC 100 to operate in E mode and assign it to VSAN 1 as a trunk port.

[SwitchA-Vfc100] fc mode f

[SwitchA-Vfc100] port trunk vsan 1

[SwitchA-Vfc100] quit

# Configure interface Ten-GigabitEthernet 1/0/1 to allow VLAN 10.

[SwitchA] interface ten-gigabitethernet1/0/1

[SwitchA-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchA-Ten-GigabitEthernet1/0/1] port trunk permit vlan 10

[SwitchA-Ten-GigabitEthernet1/0/1] quit

# Enable the fabric configuration function.

[SwitchA] vsan 1

[SwitchA-vsan1] domain configure enable

# Configure the domain ID as 1.

[SwitchA-vsan1] domain-id 1 static

Non-disruptive reconfiguration or isolating the switch may be performed. Continu

e? [Y/N]:y

[SwitchA-vsan1] quit

Switch B

Switch A

XGE1/0/1

Switch C

Domain ID: 1 Domain ID: 3

Domain ID: 2

VFC100

XGE1/0/2

VFC200

XGE1/0/3

VFC201

XGE1/0/3

VFC300