R21xx-HP FlexFabric 11900 FCoE Configuration Guide

# Enable FCoE for VLAN 10 and bind VLAN 10 to VSAN 1.

[SwitchB] vlan 10

[SwitchB-vlan10] fcoe enable vsan 1

[SwitchB-vlan10] quit

# Configure two static routes.

[SwitchB-vsan1] fc route-static 010000 8 Vfc200

[SwitchB-vsan1] fc route-static 030000 8 Vfc201

3. Configure Switch C:

# Configure Switch C to operate in advanced mode, save the configuration, and reboot Switch C.

(Skip this step if the switch is operating in advanced mode.)

<SwitchC> system-view

[SwitchC] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Configure Switch C to operate in FCF mode and bind interface VFC 300 to interface

Ten-GigabitEthernet 1/0/3.

<SwitchC> system-view

[SwitchC] fcoe-mode fcf

[SwitchC] interface Vfc 300

[SwitchC-Vfc300] bind interface Ten-GigabitEthernet1/0/3

[SwitchC-Vfc300] fc mode e

[SwitchC-Vfc300] port trunk vsan 1

[SwitchC-Vfc300] quit

# Configure interface Ten-GigabitEthernet 1/0/3 to allow VLAN 10.

[SwitchC] interface ten-gigabitethernet1/0/3

[SwitchC-Ten-GigabitEthernet1/0/3] port link-type trunk

[SwitchC-Ten-GigabitEthernet1/0/3] port trunk permit vlan 10

[SwitchC-Ten-GigabitEthernet1/0/3] quit

# Enable the fabric configuration function.

[SwitchC] vsan 1

[SwitchC-vsan1] domain configure enable

# Configure the domain ID as 3.

[SwitchC-vsan1] domain-id 3 static

Non-disruptive reconfiguration or isolating the switch may be performed. Continu

e? [Y/N]:y

[SwitchC-vsan1] quit

# Enable FCoE for VLAN 10 and bind VLAN 10 to VSAN 1.

[SwitchC] vlan 10

[SwitchC-vlan10] fcoe enable vsan 1

[SwitchC-vlan10] quit

# Configure two static routes.

[SwitchC-vsan1] fc route-static 010000 8 Vfc300

[SwitchC-vsan1] fc route-static 020000 8 Vfc300