R21xx-HP FlexFabric 11900 FCoE Configuration Guide

[SwitchA-vsan2] quit

# Enable FCoE for VLAN 10 and bind VLAN 10 to VSAN 2.

[SwitchA] vlan 10

[SwitchA-vlan10] fcoe enable vsan 2

[SwitchA-vlan10] quit

# Enable FSPF globally.

[SwitchA-vsan2] fspf enable

[SwitchA-vsan2] quit

# Enable FSPF for interface VFC 100.

[SwitchA] interface Vfc 100

[SwitchA-Vfc100] port trunk vsan 2

[SwitchA-Vfc100] undo fspf silent vsan 2

2. Configure Switch B:

# Configure Switch B to operate in advanced mode, save the configuration, and reboot Switch B.

(Skip this step if the switch is operating in advanced mode.)

<SwitchB> system-view

[SwitchB] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Configure Switch B to operate in FCF mode and bind interface VFC 100 to interface

Ten-GigabitEthernet 1/0/1.

<SwitchB> system-view

[SwitchB] fcoe-mode fcf

[SwitchA] interface Vfc 100

[SwitchA-Vfc100] bind interface Ten-GigabitEthernet1/0/1

[SwitchA-Vfc100] fc mode e

[SwitchA-Vfc100] port trunk vsan 2

[SwitchA-Vfc100] quit

# Configure interface Ten-GigabitEthernet 1/0/1 to allow VLAN 10.

[SwitchB] interface ten-gigabitethernet1/0/1

[SwitchB-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchB-Ten-GigabitEthernet1/0/1] port trunk permit vlan 10

[SwitchB-Ten-GigabitEthernet1/0/1] quit

# Enable the fabric configuration function.

[SwitchB] vsan 2

[SwitchB-vsan2] domain configure enable

# Configure the domain ID as 2.

[SwitchB-vsan2] domain-id 2 static

Non-disruptive reconfiguration or isolating the switch may be performed. Continu

e? [Y/N]:y

[SwitchB-vsan2] quit

# Enable FCoE for VLAN 10 and bind VLAN 10 to VSAN 2.

[SwitchA] vlan 10

[SwitchA-vlan10] fcoe enable vsan 2

[SwitchA-vlan10] quit