R21xx-HP FlexFabric 11900 FCoE Configuration Guide

70
Figure 24 Network diagram
Configuration considerations
To meet the preceding requirements, divide VSAN 1 into three zones as follows:
• Zone 1 consists of Server A.
• Zone 2 consists of Server B and Disks A, B, and C.
• Zone 3 consists of Server C and Disks B and C.
Configure Switch A and distribute the full zone database to Switch B:
• Create zone alias Alias 1, which consists of Disks B and C, to simplify the configuration.
• Create zone set Zoneset 1, which consists of Zones 1, 2, and 3, and activate it.
Configuration procedure
Configure Switch A only.
For information about how to configure physical-to-virtual interface bindings and VLAN-to-VSAN
mappings, see "Configuring a VFC interface" and "Enabling FCoE for a VLAN and mapping a VSAN
to
the VLAN."
# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A. (Skip
this step if the switch is operating in advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Configure Switch A to operate in FCF mode, create a zone alias Alias1, and add pWWN
22:33:44:55:66:77:88:99 (Disk B) and FC address 020004 (Disk C) as its members.
<SwitchA> system-view
[SwitchA] fcoe-mode fcf
[SwitchA] vsan 1