R21xx-HP FlexFabric 11900 FCoE Configuration Guide

Figure 26 Network diagram

Configuration procedure

# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A. (Skip

this step if the switch is operating in advanced mode.)

<SwitchA> system-view

[SwitchA] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Configure Switch A to operate in NPV mode.

<SwitchA> system-view

[SwitchA] fcoe-mode npv

# Create VSAN 10 and VLAN 20.

<SwitchA> system-view

[SwitchA] vsan 10

[SwitchA-vsan10] quit

[SwitchA] vlan 20

[SwitchA-vlan20] quit

# Configure interface Ten-GigabitEthernet 1/0/1 to allow VLAN 20.

[SwitchA] interface Ten-GigabitEthernet1/0/1

[SwitchA-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchA-Ten-GigabitEthernet1/0/1] port trunk permit vlan 20

[SwitchA-Ten-GigabitEthernet1/0/1] quit

# Configure interface Ten-GigabitEthernet 1/0/2 to allow VLAN 20.

[SwitchA] interface Ten-GigabitEthernet1/0/2

[SwitchA-Ten-GigabitEthernet1/0/2] port link-type trunk

[SwitchA-Ten-GigabitEthernet1/0/2] port trunk permit vlan 20

[SwitchA-Ten-GigabitEthernet1/0/2] quit

# Configure interface Ten-GigabitEthernet 1/0/3 to allow VLAN 20.

[SwitchA] interface Ten-GigabitEthernet1/0/3

[SwitchA-Ten-GigabitEthernet1/0/3] port link-type trunk

[SwitchA-Ten-GigabitEthernet1/0/3] port trunk permit vlan 20

[SwitchA-Ten-GigabitEthernet1/0/3] quit