R21xx-HP FlexFabric 11900 FCoE Configuration Guide

# Create interface VFC 1, bind it to interface Ten-GigabitEthernet 1/0/1, and configure it to allow VSAN

10.

[SwitchA] interface vfc 1

[SwitchA-Vfc1] bind interface Ten-GigabitEthernet1/0/1

[SwitchA-Vfc1] port trunk vsan 10

# Configure the uplink interface.

[SwitchA-vfc1] fc mode np

[SwitchA-Vfc1] quit

# Create interfaces VFC 1 and VFC 2, bind them to interfaces Ten-GigabitEthernet 1/0/2 and

Ten-GigabitEthernet 1/0/3, respectively, and configure them to allow VSAN 10.

[SwitchA] interface vfc 2

[SwitchA-Vfc2] bind interface Ten-GigabitEthernet1/0/2

[SwitchA-Vfc2] port trunk vsan 10

[SwitchA-Vfc2] quit

[SwitchA] interface vfc 3

[SwitchA-Vfc3] bind interface Ten-GigabitEthernet1/0/3

[SwitchA-Vfc3] port trunk vsan 10

[SwitchA-Vfc3] quit

# Configure the downlink interface.

[SwitchA] interface vfc 2

[SwitchA-vfc 2] fc mode f

[SwitchA-vfc 2] quit

[SwitchA] interface vfc 3

[SwitchA-vfc 3] fc mode f

[SwitchA-vfc 3] quit

# Enable FCoE for VLAN 20 and map it to VSAN 10.

[SwitchA] vlan 20

[SwitchA-vlan20] fcoe enable vsan 10

[SwitchA-vlan20] quit

Verifying the configurations

# Display the nodes on downlink interfaces and their mapped uplink interfaces.

[SwitchA] display npv login

Server External

Interface VSAN FCID Port WWN Node WWN Interface

Vfc2 1 0x010001 20:00:00:15:40:94:00:00 20:00:00:15:40:94:00:00 Vfc1

Vfc3 1 0x010002 20:00:00:42:40:94:00:01 20:00:00:42:40:94:00:01 Vfc1

# Display the status of Switch A.

[SwitchA] display npv status

External Interfaces:

Interface: Vfc1 VSAN tagging mode: Tagging

VSAN State FCID

1 Up 0x010000

Number of External Interfaces: 1

Server Interfaces: