R21xx-HP FlexFabric 11900 FCoE Configuration Guide

86
e? [Y/N]:y
[SwitchB-vsan1] quit
# Create interface VFC 200, configure it to operate in E mode, bind it to interface
Ten-GigabitEthernet 1/0/1, and assign it to VSAN 1 as a trunk port.
[SwitchB] interface vfc 200
[SwitchB-Vfc200] fc mode e
[SwitchB-Vfc200] bind interface ten-gigabitethernet1/0/1
[SwitchB-Vfc200] port trunk vsan 1
[SwitchB-Vfc200] quit
# Configure interface Ten-GigabitEthernet 1/0/1 to allow VLAN 20.
[SwitchB] interface ten-gigabitethernet1/0/1
[SwitchB-Ten-GigabitEthernet1/0/1] port link-type trunk
[SwitchB-Ten-GigabitEthernet1/0/1] port trunk permit vlan 20
[SwitchB-Ten-GigabitEthernet1/0/1] quit
# Enable FCoE for VLAN 20 and map it to VSAN 1.
[SwitchB] vlan 20
[SwitchB-vlan20] fcoe enable vsan 1
[SwitchB-vlan20] quit
# Create interface VFC 100, configure it to operate in E mode, bind it to interface
Ten-GigabitEthernet 1/0/2, and assign it to VSAN 1 as a trunk port.
[SwitchB] interface vfc 100
[SwitchB-Vfc100] fc mode e
[SwitchB-Vfc100] bind interface ten-gigabitethernet1/0/2
[SwitchB-Vfc100] port trunk vsan 1
[SwitchB-Vfc100] quit
# Configure interface Ten-GigabitEthernet 1/0/2 to allow VLAN 20.
[SwitchB] interface ten-gigabitethernet1/0/2
[SwitchB-Ten-GigabitEthernet1/0/2] port link-type trunk
[SwitchB-Ten-GigabitEthernet1/0/2] port trunk permit vlan 20
[SwitchB-Ten-GigabitEthernet1/0/2] quit
# Enable FCoE for VLAN 20 and map it to VSAN 1.
[SwitchB] vlan 20
[SwitchB-vlan20] fcoe enable vsan 1
[SwitchB-vlan20] quit
# Enable FSPF globally.
[SwitchB] vsan 1
[SwitchB-vsan1] fspf enable
3. Configure Switch C:
# Configure Switch C to operate in advanced mode, save the configuration, and reboot Switch C.
(Skip this step if the switch is operating in advanced mode.)
<SwitchC> system-view
[SwitchC] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Enable the fabric configuration function.