R21xx-HP FlexFabric 11900 Fundamentals Command Reference

228
Field Remarks
Transceiver info checksum error Transceiver information checksum error.
Transceiver type and port configuration
mismatch
The type of the transceiver module does not match the port
configuration.
Transceiver type not supported by port hardware
The port does not support the specified type of transceiver
modules.
Examples
# Display the alarms present on the transceiver module in interface GigabitEthernet 1/0/1.
<Sysname> display transceiver alarm interface gigabitethernet 1/0/1
GigabitEthernet1/0/1 transceiver current alarm information:
RX loss of signal
RX power low
Table 38 Command output
Field Descri
p
tion
transceiver current alarm information Alarms present on the transceiver module.
RX loss of signal Received signals are lost.
RX power low Received power is low.
display transceiver diagnosis
Use display transceiver diagnosis to display the current measured values of the digital diagnosis
parameters for transceiver modules.
Syntax
display transceiver diagnosis interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface [ interface-type interface-number ]: Specifies an interface by its type and number. If no interface
is specified, this command displays the current measured values of the digital diagnosis parameters for
the transceiver modules on all interfaces.
Usage guidelines
This command cannot display information for some transceiver modules.
Examples
# Display the current measured values of the digital diagnosis parameters for the transceiver module on
interface GigabitEthernet 1/0/1.
<Sysname> display transceiver diagnosis interface gigabitethernet 1/0/1