R21xx-HP FlexFabric 11900 IP Multicast Command Reference

95
MLD snooping commands
display ipv6 l2-multicast forwarding-table
Use display ipv6 l2-multicast forwarding-table to display information about Layer 2 IPv6 multicast
forwarding entries.
Syntax
In standalone mode:
display ipv6 l2-multicast forwarding-table [ group ipv6-group-address | source ipv6-source-address ] *
[ vlan vlan-id ] [ slot slot-number ]
In IRF mode:
display ipv6 l2-multicast forwarding-table [ group ipv6-group-address | source ipv6-source-address ] *
[ vlan vlan-id ] [ chassis chassis-number slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
group ipv6-group-address: Specifies an IPv6 multicast group by its IPv6 address. The value can be 0::0
or in the range of FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16, and FF0y::), where "x" and
"y" represent any hexadecimal number in the range of 0 to F. If no IPv6 multicast group is specified, this
command displays information about the Layer 2 IPv6 multicast forwarding entries for all IPv6 multicast
groups.
source ipv6-source-address: Specifies an IPv6 multicast source by its IPv6 address. If no multicast source
is specified, this command displays information about the Layer 2 IPv6 multicast forwarding entries for all
IPv6 multicast sources.
vlan vlan-id: Specifies a VLAN. The value range for the vlan-id argument is 1 to 4094. If no VLAN is
specified, this command displays information about the Layer 2 IPv6 multicast forwarding entries for all
VLANs.
slot slot-number: Specifies a card by the number of the slot where the card is inserted. If no card is
specified, this command displays information about the Layer 2 IPv6 multicast forwarding entries on the
MPU. (In standalone mode.)
chassis chassis-number slot slot-number: Specifies a card on a member device. The chassis-number
argument represents the member ID of a device in the IRF fabric, and the slot-number argument
represents the number of the slot where the card is inserted. If no member device is specified, this
command displays information about the Layer 2 IPv6 multicast forwarding entries on all MPUs in the IRF
fabric. (In IRF mode.)
Examples
# Display information about the Layer 2 IPv6 multicast forwarding entries for VLAN 2.