R21xx-HP FlexFabric 11900 IP Multicast Command Reference

37
Field Descri
p
tion
Referenced route type
Type of the referenced route:
• igp—IGP unicast route.
• egp—EGP unicast route.
• unicast (direct)—Directly connected unicast route.
• unicast—Other unicast routes, such as static unicast route.
• multicast static—Static multicast route.
Route selection rule
Rule for RPF route selection, based on the route preference of the routing
protocol or based on the longest prefix match to the destination
address.
Load splitting rule Status of the load splitting rule: enabled/disabled.
Related commands
• display multicast forwarding-table
• display multicast routing-table
ip rpf-route-static
Use ip rpf-route-static to configure a static multicast route.
Use undo ip rpf-route-static to delete a specified static multicast route.
Syntax
ip rpf-route-static source-address { mask-length | mask } { rpf-nbr-address | interface-type
interface-number } [ preference preference ]
undo ip rpf-route-static source-address { mask-length | mask } { rpf-nbr-address | interface-type
interface-number }
Default
No static multicast route exists.
Views
System view
Predefined user roles
network-admin
Parameters
source-address: Specifies a multicast source address.
mask-length: Specifies the address mask length, in the range of 0 to 32.
mask: Specifies the address mask.
rpf-nbr-address: Specifies an RPF neighbor by its IP address.
interface-type interface-number: Specifies an interface by its type and number. The interface connects the
RPF neighbor.
preference: Specifies a route preference, in the range of 1 to 255. The default value is 1.