R21xx-HP FlexFabric 11900 IP Multicast Command Reference

85
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim timer hello 40
Related commands
timer hello (PIM view)
pim timer join-prune
Use pim timer join-prune to set interval for sending the join/prune messages on an interface.
Use undo pim timer join-prune to restore the default.
Syntax
pim timer join-prune interval
undo pim timer join-prune
Default
The interval for sending the join/prune messages is 60 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
interval: Sets an interval (in seconds) for sending the join/prune messages, in the range of 0 to 18000.
A value of 0 means that no join or prune messages are sent.
Usage guidelines
You can set the interval for sending the join/prune messages in PIM view or interface view. The
configurations made in PIM view are effective on all interfaces, and the configurations made in interface
view are effective on only the current interface. If you set the interval in both PIM view and interface view,
the configuration in interface view always takes precedence.
Examples
# Set the interval for sending the join/prune messages to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim timer join-prune 80
Related commands
timer join-prune (PIM view)
pim triggered-hello-delay
Use pim triggered-hello-delay to set the maximum delay for sending a hello message.
Use undo pim triggered-hello-delay to restore the default.
Syntax
pim triggered-hello-delay delay