R21xx-HP FlexFabric 11900 IP Multicast Configuration Guide

41
• You can configure static multicast MAC address entries on the specified interface in system view, or
on the current interface in interface view.
• The multicast MAC address that can be manually configured in the multicast MAC address entry
must be unused. (The least significant bit of the most significant octet is 1.)
To configure a static multicast MAC address entry in system view:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Configure a static multicast
MAC address entry.
mac-address multicast
mac-address interface interface-list
vlan vlan-id
By default, no static multicast MAC
address entries exist.
To configure a static multicast MAC address entry in interface view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Ethernet interface/Layer 2
aggregate interface view.
interface interface-type
interface-number
N/A
3. Configure a static multicast MAC
address entry.
mac-address multicast
mac-address vlan vlan-id
By default, no static multicast
MAC address entries exist.
Displaying and maintaining multicast routing and
forwarding
CAUTION:
The reset commands might cause multicast data transmission failures.
Execute display commands in any view and reset command in user view.
Task Command
Display information about
static multicast MAC
address table.
display mac-address [ mac-address [ vlan vlan-id ] | [ multicast ] [ vlan vlan-id ]
[ count ] ]
Display multicast boundary
information.
display multicast boundary [ group-address [ mask-length | mask ] ] [ interface
interface-type interface-number ]
Display multicast
forwarding table
information (in standalone
mode).
display multicast forwarding-table [ source-address [ mask { mask-length |
mask } ] | group-address [ mask { mask-length | mask } ] | incoming-interface
interface-type interface-number | outgoing-interface { exclude | include |
match } interface-type interface-number | slot slot-number | statistics ] *