R21xx-HP FlexFabric 11900 IRF Command Reference

19
Predefined user roles
network-admin
Parameters
port-number: Specifies an IRF port number, which must be 1 or 2.
Usage guidelines
To set up an IRF link between two devices, you must enter IRF port view to bind physical ports to the IRF
port used by each device for IRF connection.
Before removing all port bindings on an IRF port, shut down all its physical ports.
Examples
# In standalone mode, enter IRF-port 1 view.
<Sysname> system-view
[Sysname] irf-port 1
[Sysname-irf-port1]
Related commands
port group interface
irf-port-configuration active
Use irf-port-configuration active to activate IRF port settings.
Syntax
irf-port-configuration active
Views
System view
Predefined user roles
network-admin
Usage guidelines
After connecting the physical ports between two devices and binding them to the correct IRF ports, you
must use this command to activate the settings on the IRF ports to merge the two devices into one IRF
fabric.
The system automatically activates the IRF port settings in the following situations:
• The configuration file that the device starts with contains IRF port bindings.
• You are binding physical ports to an IRF port after an IRF fabric is formed.
Examples
To configure and activate IRF port 1/2:
# Bind Ten-GigabitEthernet 1/1/0/27 to it.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/1/0/27
[Sysname-Ten-GigabitEthernet1/1/0/27] shutdown
[Sysname-Ten-GigabitEthernet1/1/0/27] quit
[Sysname] irf-port 1/2
[Sysname-irf-port1/2] port group interface Ten-GigabitEthernet 1/1/0/27