R21xx-HP FlexFabric 11900 IRF Configuration Guide

[Sysname-irf-port2] quit

# Enable enhanced IRF mode.

[Sysname] irf mode enhanced

# Save the configuration.

[Sysname] save

# Connect Device B to Device A as shown in Figure 17. Log in to Device B.

# Enable IRF mode.

<Sysname> system-view

[Sysname] chassis convert mode irf

The device will switch to IRF mode and reboot. You are recommended to save the current

running configuration and specify the configuration file for the next startup.

Continue? [Y/N]:y

Do you want to convert the content of the next startup configuration file

flash:/startup.cfg to make it available in IRF mode? [Y/N]:y

Please wait...

Saving the converted configuration file to the main board succeeded.

Slot 1:

Saving the converted configuration file succeeded.

Now rebooting, please wait...

Device B and Device A form an IRF fabric after Device B reboots.

3. Configure Device C:

# Assign member ID 3 and member priority 6 to Device C.

<Sysname> system-view

[Sysname] irf member 3

[Sysname] irf priority 6

# Bind Ten-GigabitEthernet 3/0/2 and Ten-GigabitEthernet 3/0/1 to IRF-port 1 and IRF-port 2,

respectively.

[Sysname] irf-port 1

[Sysname-irf-port1] port group interface ten-gigabitethernet 3/0/2

[Sysname-irf-port1] quit

[Sysname] irf-port 2

[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/1

[Sysname-irf-port2] quit

# Enable enhanced IRF mode.

[Sysname] irf mode enhanced

# Save the configuration.

[Sysname] save

# Connect Device C to Device B as shown in Figure 17. Log in to Device C.

# Enable IRF mode.

<Sysname> system-view

[Sysname] chassis convert mode irf

The device will switch to IRF mode and reboot. You are recommended to save the current

running configuration and specify the configuration file for the next startup.

Continue? [Y/N]:y