R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

7
Table 3 Command output
Field Description
Ten-GigabitEthernet1/0/1 current state
State of the interface:
• Administratively DOWN—The Ethernet interface was shut down
with the shutdown command. The interface is administratively
down.
• DOWN—The Ethernet interface is administratively up but
physically down (possibly because no physical link is present or
the link has failed).
• UP—The Ethernet interface is both administratively and
physically up.
Line protocol current state
Link layer state of the interface. The state is determined through
parameter negotiation on the link layer.
Hold timer is Link-up or link-down event suppression interval.
Internet protocol processing: disabled Indicates that the interface cannot process IP packets.
Last clearing of counters
Time when the reset counters interface command was last used to
clear the interface statistics. Never indicates the reset counters
interface command has never been used on the interface since the
switch's startup.
Last 300 seconds input rate Average input rate over the last 300 seconds in Bps, bps, and pps.
Last 300 seconds output rate
Average output rate over the last 300 seconds in Bps, bps, and
pps.
Input
Number and size (in bytes) of input packets, and the number of
buffers for input packets.
Output Number and size (in bytes) of output packets.
# Display detailed information about Layer 2 interface Ten-GigabitEthernet 1/0/1.
<Sysname> display interface ten-gigabitethernet 1/0/1
Ten-GigabitEthernet1/0/1 current state: DOWN
Line protocol current state: DOWN
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0023-8912-3d06
Description: Ten-GigabitEthernet1/0/1 Interface
Loopback is not set
Media type is not sure,Port hardware type is No connector
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 9216
Allow jumbo frame to pass
Broadcast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Unicast MAX-ratio: 100%
PVID: 1
Mdi type: automdix
Port link-type: access
Tagged Vlan: none