R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

UnTagged Vlan: 1

Port priority: 0

Last clearing of counters: Never

Peak value of input: 0 bytes/sec, at 2012-10-10 10:06:20

Peak value of output: 0 bytes/sec, at 2012-10-10 10:06:20

Last 300 seconds input: 0 packets/sec 0 bytes/sec -%

Last 300 seconds output: 0 packets/sec 0 bytes/sec -%

Input (total): 0 packets, 0 bytes

0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses

Input (normal): 0 packets, - bytes

0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses

Input: 0 input errors, 0 runts, 0 giants, 0 throttles

0 CRC, 0 frame, - overruns, 0 aborts

- ignored, - parity errors

Output (total): 0 packets, 0 bytes

0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses

Output (normal): 0 packets, - bytes

0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses

Output: 0 output errors, - underruns, - buffer failures

0 aborts, 0 deferred, 0 collisions, 0 late collisions

0 lost carrier, - no carrier

Table 4 Command output

Field Description

Ten-GigabitEthernet1/0/1 current state

State of the Ethernet interface:

• Administratively DOWN—The Ethernet interface was shut down

with the shutdown command. The interface is administratively

down.

• DOWN—The Ethernet interface is administratively up but

physically down (possibly because no physical link is present or

the link has failed).

• UP—The Ethernet interface is both administratively and

physically up.

Line protocol current state

Link layer state of the interface. The state is determined through

parameter negotiation on the link layer.

IP Packet Frame Type

Ethernet framing format. PKTFMT_ETHNT_2 indicates that the

frames are encapsulated in Ethernet II framing format.

Hardware address MAC address of the interface.

Loopback is set internal An internal loopback test is running on the Ethernet interface.

Loopback is set external An external loopback test is running on the Ethernet interface.

Loopback is not set No loopback test is running on the Ethernet interface.

100Mbps-speed mode The interface is operating at 100 Mbps.

1000Mbps-speed mode The interface is operating at 1000 Mbps.

10Gbps-speed mode The interface is operating at 10 Gbps.

40Gbps-speed mode The interface is operating at 40 Gbps.