R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

160
Related commands
display vlan
port access vlan
Use port access vlan to assign the access ports to the specified VLAN.
Use undo port access vlan to restore the default.
Syntax
port access vlan vlan-id
undo port access vlan
Default
All access ports belong to VLAN 1.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, S-channel interface view
Predefined user roles
network-admin
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094. Make sure the VLAN specified by the VLAN ID
already exists.
Usage guidelines
Before assigning an access port to VLAN, make sure the VLAN has been created.
• The configuration made in Layer 2 Ethernet interface view applies only to the port.
• The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and
its aggregation member ports.
{ If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
{ If the system fails to apply the configuration to an aggregation member port, it skips the port
and moves to the next member port.
• The configuration made in S-channel interface view applies only to the interface. For information
about S-channel interfaces, see EVB Configuration Guide.
Examples
# Assign Ten-GigabitEthernet 1/0/1 to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port access vlan 3
port hybrid pvid
Use port hybrid pvid to configure the PVID of the hybrid port.
Use undo port hybrid pvid to restore the default.