R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

165
Default
The PVID of a trunk port is VLAN 1.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, S-channel interface view
Predefined user roles
network-admin
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
You can use a nonexistent VLAN as the PVID for a trunk port. If you remove the PVID of a trunk port with
the undo vlan command, the setting of the PVID on the port is not affected.
The local and remote trunk ports must use the same PVID for the packets of the PVID to be transmitted
correctly.
You must configure the trunk port to allow and forward packets from the PVID by using the port trunk
permit vlan command.
• The configuration made in Layer 2 Ethernet interface view applies only to the port.
• The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and
its aggregation member ports.
{ If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
{ If the system fails to apply the configuration to an aggregation member port, it skips the port
and moves to the next member port.
• The configuration made in S-channel interface view applies only to the interface.
Examples
# Configure VLAN 100 as the PVID of the trunk port Ten-GigabitEthernet 1/0/1, and assign
Ten-GigabitEthernet 1/0/1 to VLAN 100.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] port link-type trunk
[Sysname-Ten-GigabitEthernet1/0/1] port trunk pvid vlan 100
[Sysname-Ten-GigabitEthernet1/0/1] port trunk permit vlan 100
Related commands
• port link-type
• port trunk permit vlan