R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

13
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
XGE1/0/2 UP UP 10.1.1.2 Link to CoreRouter
Loop0 UP UP(s) 2.2.2.9
NULL0 UP UP(s) --
Vlan1 UP DOWN --
Vlan999 UP UP 192.168.1.42
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down
Speed or Duplex: (a)/A - auto; H - half; F - full
Type: A - access; T - trunk; H - hybrid
Interface Link Speed Duplex Type PVID Description
XGE1/0/2 DOWN auto A A 1
XGE1/0/3 UP 1000M(a) F(a) A 1 aaaaaaaaaaaaaaaaaaaaaaaaaaa
XGE1/0/4 DOWN auto A A 1
XGE1/0/5 DOWN auto A A 1
XGE1/0/6 UP 1000M(a) F(a) A 1
XGE1/0/7 DOWN auto A A 1
XGE1/0/8 UP 1000M(a) F(a) A 1
XGE1/0/9 UP 1000M(a) F(a) A 999
# Display brief information about interface Ten-GigabitEthernet 1/0/3, including the full description of
the interface.
<Sysname> display interface ten-gigabitethernet 1/0/3 brief description
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down
Speed or Duplex: (a)/A - auto; H - half; F - full
Type: A - access; T - trunk; H - hybrid
Interface Link Speed Duplex Type PVID Description
XGE1/0/3 UP 1000M(a) F(a) A 1 aaaaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Table 5 Command output
Field Description
The brief information of interface(s)
under route mode:
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
• ADM—The interface has been shut down by the network
administrator. To recover its physical layer state, run the undo
shutdown command.
• Stby—The interface is a standby interface.
Protocol: (s) – spoofing
If the network layer protocol of an interface is UP, but its link is an
on-demand link or not present at all, this field displays UP (s), where s
represents the spoofing flag. This attribute is typical of interface Null 0
and loopback interfaces.
Interface Interface name.