R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

193
Parameters
txrx: Specifies the TxRx mode. A port in this mode can send and receive LLDPDUs.
Examples
# Configure the operating mode for the LLDP nearest non-TPMR bridge as TxRx on Ten-GigabitEthernet
1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp agent nearest-nontpmr admin-status txrx
lldp check-change-interval
Use lldp check-change-interval to enable LLDP polling and set the polling interval.
Use undo lldp check-change-interval to disable LLDP polling.
Syntax
lldp check-change-interval interval
undo lldp check-change-interval
Default
LLDP polling is disabled.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
interval: Sets the LLDP polling interval in the range of 1 to 30 seconds.
Examples
# Enable LLDP polling on Ten-GigabitEthernet 1/0/1 and set the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp check-change-interval 30
lldp compliance admin-status cdp
Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP.
Use undo lldp compliance admin-status cdp to restore the default.
Syntax
lldp compliance admin-status cdp { disable | txrx }
undo lldp compliance admin-status cdp
Default
CDP-compatible LLDP operates in disable mode.