R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

202
If the LLDPDU transmit interval is less than the LLDPDU transmit delay, the device uses the LLDPDU transmit
delay as the transmit interval.
Examples
# Set the LLDPDU transmit interval to 20 seconds.
<Sysname> system-view
[Sysname] lldp timer tx-interval 20
Related commands
lldp timer tx-delay
lldp tlv-enable
Use lldp tlv-enable to configure the types of advertisable TLVs.
Use undo lldp tlv-enable to disable the advertising of specific types of TLVs.
Syntax
In Layer 2 Ethernet interface view:
lldp tlv-enable { basic-tlv { all | management-address-tlv [ ip-address ] | port-description |
system-capability | system-description | system-name } | dot1-tlv { all | dcbx | port-vlan-id |
protocol-vlan-id [ vlan-id ] | vlan-name [ vlan-id ] } | dot3-tlv { all | link-aggregation | mac-physic |
max-frame-size | power } | med-tlv { all | capability | inventory | location-id { civic-address
device-type country-code { ca-type ca-value }&<1-10> | elin-address tel-number } | network-policy |
power-over-ethernet } }
undo lldp tlv-enable { basic-tlv { all | management-address-tlv [ ip-address ] | port-description |
system-capability | system-description | system-name } | dot1-tlv { all | dcbx | port-vlan-id |
protocol-vlan-id [ vlan-id ] | vlan-name [ vlan
-i
d ] } | dot3-tlv { all | link-aggregation | mac-physic |
max-frame-size | power } | med-tlv { all | capability | inventory | location-id | network-policy |
power-over-ethernet } }
In Layer 3 Ethernet interface view:
lldp tlv-enable { basic-tlv { all | management-address-tlv [ ip-address ] | port-description |
system-capability | system-description | system-name } | dot3-tlv { all | link-aggregation | mac-physic
| max-frame-size | power } | med-tlv { all | capability | inventory | location-id { civic-address
device-type country-code { ca-type ca-value }&<1-10> | elin-address tel-number } |
power-over-ethernet } }
undo lldp tlv-enable { basic-tlv { all | management-address-tlv [ ip-address ] | port-description |
system-capability | system-description | system-name } |
dot3-tlv { all | link-aggregation | mac-physic
| max-frame-size | power } | med-tlv { all | capability | inventory | location-id |
power-over-ethernet } }
Default
The device can advertise on a Layer 2 Ethernet port all types of LLDP TLVs except DCBX TLVs, location
identification TLVs, VLAN Name TLVs, and Protocol VLAN ID TLVs, and advertise on a Layer 3 Ethernet
port all types of LLDP TLVs, except IEEE 802.1 organizationally specific TLVs, network policy TLVs, and
location identification TLVs.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view