R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

28
GE copper ports do not support the 10000 or 40000 keyword.
Examples
# Configure Ten-GigabitEthernet 1/0/1 to autonegotiate the speed.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] speed auto
using fortygige
Use using fortygige to combine four 10-GE interfaces that are split from a 40-GE interface into a 40-GE
interface.
Use undo using fortygige to cancel the configuration.
Syntax
using fortygige
undo using fortygige
Default
The 10-GE interfaces that are split from a 40-GE interface are used as single interfaces, and are not
automatically combined.
Views
Split 10-GE interface view
Predefined user roles
network-admin
Usage guidelines
If you need higher bandwidth, you can combine four 10-GE interfaces that are split from a 40-GE
interface into a 40-GE interface. To make this command take effect on the four split 10-GE interfaces,
execute this command on only one of the split 10-GE interfaces.
After this command is successfully configured, you must reboot the corresponding interface card and
then the system deletes the four 10-GE interfaces and creates the combined 40-GE interface.
Examples
# Combine 10-GE interfaces Ten-GigabitEthernet 1/0/1:1 through Ten-GigabitEthernet 1/0/1:4 into a
40-GE interface.
<System> system-view
[System] interface ten-gigabitethernet 1/0/1:1
[System-Ten-GigabitEthernet1/0/1:1] using fortygige
The interfaces Ten-GigabitEthernet1/0/1:1 through Ten-GigabitEthernet1/0/1:4 will be
deleted. Continue? [Y/N]:y
Reboot device to make the configuration take effect.
Related commands
using tengige
using tengige
Use using tengige to split a 40-GE interface into four 10-GE interfaces.