R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

45
Field Descri
p
tion
Last 300 seconds output: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Average output rate over the last 300 seconds (displayed when the
interface supports traffic statistics collection):
• packets/sec—Average number of packets sent per second.
• bytes/sec—Average number of bytes sent per second.
• bits/sec—Average number of bits sent per second.
0 packets input, 0 bytes, 0 drops
Amount of incoming traffic in packets and in bytes, and the total
number of dropped incoming packets (displayed when the interface
supports traffic statistics collection).
0 packets output, 0 bytes, 0 drops
Total number and size (in bytes) of outgoing packets of the interface
and the number of dropped packets (displayed when the interface
supports traffic statistics collection).
# Display brief information about all loopback interfaces.
<Sysname> display interface loopback brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
Loop1 UP UP(s) -- aaaaaaaaaaaaaaaaaaaaaaaaaaa
# Display brief information about all existing loopback interfaces, including the full description of each
loopback interface.
<Sysname> display interface loopback brief description
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
Loop1 UP UP(s) -- aaaaaaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Table 12 Command output
Field Description
The brief information of interface(s)
under route mode:
Brief information about loopback interfaces.
Link: ADM - administratively down;
Stby - standby
• ADM—The interface has been shut down by the network
administrator. To recover its physical layer state, run the undo
shutdown command.
• Stby—The interface is a standby interface.
Protocol: (s) – spoofing
If the network layer protocol of an interface is up but its link is an
on-demand link or not present at all, this field displays UP (s), where s
represents the spoofing flag. This attribute is typical of interface Null 0
and loopback interfaces.
Interface Interface name.