R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

53
To view the member interfaces of an interface range, use the display current-configuration | include
"interface range" command.
To bulk configure interfaces, follow these guidelines:
• If you cannot enter the view of an interface by using the interface interface-type interface-number
command, do not configure the interface as the first interface in the interface range.
• Do not assign an aggregate interface and any of its member interfaces to an interface range at the
same time. Some commands, after being executed on both an aggregate interface and its member
interfaces, can break up the aggregation.
• No limit is set on the maximum number of interfaces in an interface range. The more interfaces in
an interface range, the longer the command execution time.
Examples
# Add Ten-GigabitEthernet 1/0/1 through Ten-GigabitEthernet 1/0/12 to interface range named
myEthPort, and enter the interface range view.
<Sysname> system-view
[Sysname] interface range name myEthPort interface ten-gigabitethernet 1/0/1 to
ten-gigabitethernet 1/0/12
[Sysname-if-range-myEthPort]
# Enter the view of interface range named myEthPort.
<Sysname> system-view
[Sysname] interface range name myEthPort
[Sysname-if-range-myEthPort]