R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

87
Usage guidelines
This command takes effect on only known unicast packets and can change the global load sharing
criteria for known unicast packets. Broadcast packets, multicast packets, and unknown unicast packets
always use the default global load sharing criteria.
The load sharing criteria that you configure overwrite the previous criteria.
If unsupported load sharing criteria are configured, an error prompt appears.
In system view, the switch supports the following load-sharing criteria and combinations:
• Load-sharing criteria automatically determined based on the packet type
• Source IP address
• Destination IP address
• Source MAC address
• Destination MAC address
• Source IP address and destination IP address
• Source IP address and source port
• Destination IP address and destination port
• Source IP address, source port, destination IP address, and destination port
• Any combination of ingress port, source MAC address, and destination MAC address
Examples
# Configure the destination MAC address as the global link-aggregation load sharing criterion.
<Sysname> system-view
[Sysname] link-aggregation global load-sharing mode destination-mac
Related commands
link-aggregation load-sharing mode
link-aggregation lacp traffic-redirect-notification enable
Use link-aggregation lacp traffic-redirect-notification enable to enable link-aggregation traffic
redirection.
Use undo link-aggregation lacp traffic-redirect-notification enable to disable link-aggregation traffic
redirection.
Syntax
link-aggregation lacp traffic-redirect-notification enable
undo link-aggregation lacp traffic-redirect-notification enable
Default
Link-aggregation traffic redirection is disabled.
Views
System view
Predefined user roles
network-admin