R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Command Reference

91
undo link-aggregation port-priority
Default
The port priority of an interface is 32768.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
port-priority: Specifies the port priority in the range of 0 to 65535. The smaller the value, the higher the
port priority.
Examples
# Set the port priority of Layer 2 Ethernet interface Ten-GigabitEthernet 1/0/1 to 64.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] link-aggregation port-priority 64
Related commands
lacp system-priority
link-aggregation selected-port maximum
Use link-aggregation selected-port maximum to configure the maximum number of Selected ports
allowed in the aggregation group.
Use undo link-aggregation selected-port maximum to restore the default setting.
Syntax
link-aggregation selected-port maximum number
undo link-aggregation selected-port maximum
Default
The maximum number of Selected ports allowed in an aggregation group depends on the hardware
capabilities of the member ports.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
number: Specifies the maximum number of Selected ports allowed in an aggregation group. The value
range for this argument is 1 to 16.
Usage guidelines
Executing this command may cause some of the selected member ports in an aggregation group to
become unselected.