R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Configuration Guide

108
Ste
p
Command Remarks
2. Enter interface view.
• Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
• Enter S-channel interface
view:
interface s-channel
interface-number.channel-id
Use one of the commands.
• The configuration made in Layer 2
Ethernet interface view applies
only to the port.
• The configuration made in Layer 2
aggregate interface view applies
to the aggregate interface and its
aggregation member ports. If the
system fails to apply the
configuration to an aggregation
member port, it skips the port and
moves to the next member port. If
the system fails to apply the
configuration to the aggregate
interface, it stops applying the
configuration to aggregation
member ports.
• The configuration made in
S-channel interface view applies
only to the interface. For more
information about S-channel
interfaces, see EVB Configuration
Guide.
3. Configure the link type of the
ports as access.
port link-type access By default, all ports are access ports.
4. (Optional.) Assign the access
ports to a VLAN.
port access vlan vlan-id
By default, all access ports belong to
VLAN 1.
Assigning a trunk port to a VLAN
A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view.
When you assign a trunk port to a VLAN, follow these guidelines:
• To change the link type of a port from trunk to hybrid or vice versa, set the link type to access first.
• You must configure the trunk port to allow packets from the PVID to pass through by using the port
trunk permit vlan command.
To assign a trunk port to one or multiple VLANs:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A