R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Configuration Guide

117
On a QinQ-enabled port, you cannot configure the SVLAN TPID.
EVB and SVLAN TPID configuration are mutually exclusive. Do not configure the two features both on a
port.
To configure the SVLAN TPID on a service provider-side port:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
N/A
3. Configure the SVLAN TPID.
qinq ethernet-type service-tag
hex-value
The default setting is 0x8100 for
SVLAN tags.
Setting the 802.1p priority in SVLAN tags
By default, the device copies the 802.1p priority in the CVLAN tag to the SVLAN tag.
To set the 802.1p priority in SVLAN tags:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a traffic class and
enter traffic class view.
traffic classifier classifier-name [ operator
{ and | or } ]
By default, no traffic class is
configured.
3. Configure CVLAN match
criteria.
• Match CVLAN IDs:
if-match customer-vlan-id vlan-id-list
• Match 802.1p priority:
if-match customer-dot1p
dot1p-value&<1-8>
Use either command.
4. Return to system view.
quit N/A
5. Create a traffic behavior
and enter traffic behavior
view.
traffic behavior behavior-name N/A
6. Configure a priority
marking action for SVLAN
tags.
• Replace the priority in the SVLAN tags of
matching frames with the configured
priority:
remark dot1p dot1p-value
• Copy the 802.1p priority in the CVLAN
tag to the SVLAN tag:
remark dot1p customer-dot1p-trust
Use either command.
7. Return to system view.
quit N/A