Manualshelf

R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP FlexFabric 11000 Switch Products
131132133134135136137138139140
129
Ste
p
Command
Remarks
1. Enter system view. system-view N/A
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
N/A
3. Configure the link type of the
port as hybrid.
port link-type hybrid
By default, the link type of a
port is access.
4. Assign the port to the original
VLANs.
port hybrid vlan vlan-list { tagged |
untagged }
By default, a hybrid port is only
an untagged member of VLAN
1.
5. Assign the port to the
translated outer VLANs as an
untagged member.
port hybrid vlan vlan-list untagged
By default, a hybrid port is
only an untagged member of
VLAN 1.
6. Configure one-to-two VLAN
mapping.
vlan mapping nest { range
vlan-range-list | single vlan-id-list }
nested-vlan vlan-id
By default, VLAN mapping is
not configured on an
interface.
Configuring two-to-two VLAN mapping
Perform two-to-two VLAN mapping on an edge device that connects two SP networks, for example, on
PE 3 in Figure 34. Tw
o-to-two VLAN mapping enables two remote sites in different VLANs to
communicate at Layer 2 across two service provider networks that use different VLAN assignment
schemes.
Before configuring two-to-two VLAN mapping, first create the original VLANs and the translated VLANs.
Two-to-two VLAN mapping must be configured on the customer-side port.
To configure two-to-two VLAN mapping:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
N/A
3. Set the link type of the port.
• Configure the port as a trunk port:
port link-type trunk
• Configure the port as a hybrid
port:
port link-type hybrid
By default, the link type of a
port is access.