R21xx-HP FlexFabric 11900 Layer 2 LAN Switching Configuration Guide

130

Ste

Command

Remarks

4. Assign the port to the original

VLANs and the translated

VLANs.

• port trunk permit vlan vlan-list

• port hybrid vlan vlan-list tagged

Use one of the commands.

By default, a trunk port is

assigned to only VLAN 1, and

a hybrid port is only an

untagged member of VLAN 1.

5. Configure two-to-two VLAN

mapping.

vlan mapping tunnel outer-vlan-id

inner-vlan-id translated-vlan

outer-vlan-id inner-vlan-id

By default, VLAN mapping is

not configured on an interface.

Displaying and maintaining VLAN mapping

Execute the display commands in user view.

Task Command

Display VLAN mapping

information.

display vlan mapping [ interface interface-type interface-number ]

VLAN mapping configuration examples

One-to-one VLAN mapping configuration example

Network requirements

As shown in Figure 39:

• Each home is offered PC, VoD, and VoIP services, connects to a wiring-closet switch through the

home gateway, and obtains the IP address through DHCP.

• VLAN 1 is assigned to PC traffic, VLAN 2 is assigned to VoD traffic, and VL AN 3 is assigned to VoIP

service traffic on the home gateways.

To isolate traffic of the same service type from different homes, assign one VLAN to each type of traffic

from each home on the wiring-closet switches.