R21xx-HP FlexFabric 11900 Layer 3 IP Routing Command Reference

375
an internal router to a Type-2 external route’s destination equals the cost from the ASBR to the Type-2
external route's destination.
The import-route command cannot redistribute default routes.
The import-route bgp4+ command redistributes only EBGP routes. The import-route bgp4+ allow-ibgp
command redistributes both EBGP and IBGP routes, and might cause routing loops. Therefore, use it with
caution.
Examples
# Configure OSPFv3 process 1 to redistribute routes from RIPng and specify the type as type 2 and cost
as 50.
<Sysname> system-view
[Sysname] ospfv3
[Sysname-ospfv3-1] import-route ripng 10 type 2 cost 50
# Configure OSPFv3 process 100 to redistribute the routes discovered by OSPFv3 process 160.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] import-route ospfv3 160
Related commands
default-route-advertise (OSPFv3 area view)
log-peer-change
Use log-peer-change to enable the logging of neighbor state changes.
Use undo log-peer-change to disable the logging of neighbor state changes.
Syntax
log-peer-change
undo log-peer-change
Default
The logging of neighbor state changes is enabled.
Views
OSPFv3 view
Predefined user roles
network-admin
Usage guidelines
This feature enables the device to output information about neighbor state changes to the configuration
terminal.
Examples
# Disable the logging of neighbor state changes for OSPFv3 process 100.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] undo log-peer-change