R21xx-HP FlexFabric 11900 Layer 3 IP Routing Command Reference

383
ospfv3 timer dead
Use ospfv3 timer dead to configure the OSPFv3 neighbor dead time.
Use undo ospfv3 timer dead to restore the default.
Syntax
ospfv3 timer dead seconds [ instance instance-id ]
undo ospfv3 timer dead [ instance instance-id ]
Default
The OSPFv3 neighbor dead time is 40 seconds for P2P and broadcast interfaces, and is 120 seconds for
P2MP and NBMA interfaces.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the dead time in the range of 1 to 65535 seconds.
Usage guidelines
OSPFv3 neighbor dead time: if an interface receives no hello packet from a neighbor after dead time
elapses, the interface will consider the neighbor dead.
The dead time must be at least four times the hello time and must be identical on interfaces attached to
the same network segment.
Examples
# Configure the OSPFv3 neighbor dead time as 60 seconds for VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer dead 60
Related commands
ospfv3 timer hello
ospfv3 timer hello
Use ospfv3 timer hello to configure the hello interval for an interface.
Use undo ospfv3 timer hello to restore the default.
Syntax
ospfv3 timer hello seconds [ instance instance-id ]
undo ospfv3 timer hello [ instance instance-id ]
Default
The hello interval is 10 seconds for P2P and broadcast interfaces, and is 30 seconds for P2MP or NBMA
interfaces.