R21xx-HP FlexFabric 11900 Layer 3 IP Routing Command Reference

385
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer poll 120
Related commands
ospfv3 timer hello
ospfv3 timer retransmit
Use ospfv3 timer retransmit to configure the LSA retransmission interval for an interface.
Use undo ospfv3 timer retransmit to restore the default.
Syntax
ospfv3 timer retransmit seconds [ instance instance-id ]
undo ospfv3 timer retransmit [ instance instance-id ]
Default
The interval defaults to 5 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the LSA retransmission interval in the range of 1 to 3600 seconds.
instance-id: Specifies an instance by its ID in the range of 0 to 255, The default is 0.
Usage guidelines
After the device sends an LSA to its neighbor, it waits for an acknowledgement. If the device receives no
acknowledgement after the LSA retransmission interval elapses, it will retransmit the LSA.
The LSA retransmission interval should not be too small for avoidance of unnecessary retransmissions.
Examples
# Configure the LSA retransmission interval on VLAN-interface 10 in instance 1 as 12 seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer retransmit 12 instance 1
ospfv3 trans-delay
Use ospfv3 trans-delay to configure the transmission delay for an interface.
Use undo ospfv3 trans-delay to restore the default.
Syntax
ospfv3 trans-delay seconds [ instance instance-id ]
undo ospfv3 trans-delay [ instance instance-id ]