R21xx-HP FlexFabric 11900 Layer 3 IP Routing Command Reference

52
value: Add an additional metric to outbound routes, in the range of 1 to 16.
Usage guidelines
With the command configured on an interface, the metric of RIP routes sent on the interface will be
increased.
If a routing policy is referenced with the route-policy keyword, the following operations can be
performed:
• Routes matching the policy is added with the metric specified in the apply cost command
configured in the policy. Routes not matching it are added with the metric specified in the rip
metricout command. The rip metricout command does not support the + or – keyword—used to
add or reduce a metric—specified in the apply cost command.
• If the apply cost command is not configured in the policy, all the outbound routes are added with
the metric specified in the rip metricout command.
Examples
# Configure VLAN-interface 10 to add a metric of 6 to the outbound route 1.0.0.0/8 and to add a
metric of 2 to other outbound routes.
<Sysname> system-view
[Sysname] ip prefix-list 123 permit 1.0.0.0 8
[Sysname] route-policy abc permit node 0
[Sysname-route-policy-abc-10] if-match ip address prefix-list 123
[Sysname-route-policy-abc-10] apply cost 6
[Sysname-route-policy-abc-10] quit
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip metricin route-policy abc 2
Related commands
apply cost
rip output
Use rip output to enable an interface to send RIP messages.
Use undo rip output to disable an interface from sending RIP messages.
Syntax
rip output
undo rip output
Default
An interface receives RIP messages.
Views
Interface view
Predefined user roles
network-admin
Examples
# Disable VLAN-interface 10 from sending RIP messages.
<Sysname> system-view