Manualshelf

R21xx-HP FlexFabric 11900 Layer 3 IP Routing Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP FlexFabric 11000 Switch Products
11121314151617181920
2
2.2.2.0/24 Static 60 0 12.2.2.2 Vlan2
80.1.1.0/24 OSPF 10 2 80.1.1.1 Vlan3
...
A route entry includes the following key items:
• Destination—IP address of the destination host or network.
• Mask—Mask length of the IP address.
• Pre—Preference of the route. Among routes to the same destination, the route with the highest
preference is optimal.
• Cost—If multiple routes to a destination have the same preference, the one with the smallest cost is
the optimal route.
• NextHop—Next hop.
• Interface—Output interface.
Dynamic routing protocols
Static routes work well in small, stable networks. They are easy to configure and require fewer system
resources. However, in networks where topology changes occur frequently, a typical practice is to
configure a dynamic routing protocol. Compared with static routing, a dynamic routing protocol is
complicated to configure, requires more routers resources, and consumes more network resources.
Dynamic routing protocols dynamically collect and report reachability information to adapt to topology
changes. They are suitable for large networks.
Dynamic routing protocols can be classified by different criteria, as shown in Table 2.
Table 2 Categories of
dynamic routing protocols
Criterion Categories
Operation scope
• IGPs—Work within an AS. Examples include RIP, OSPF, and IS-IS.
• EGPs—Work between ASs. The most popular EGP is BGP.
Routing algorithm
• Distance-vector protocols—Examples include RIP and BGP. BGP is also considered
a path-vector protocol.
• Link-state protocols—Examples include OSPF and IS-IS.
Destination address
type
• Unicast routing protocols—Examples include RIP, OSPF, BGP, and IS-IS.
• Multicast routing protocols—Examples include PIM-SM and PIM-DM.
IP version
• IPv4 routing protocols—Examples include RIP, OSPF, BGP, and IS-IS.
• IPv6 routing protocols—Examples include RIPng, OSPFv3, IPv6 BGP, and IPv6 IS-IS.
An AS refers to a group of routers that use the same routing policy and work under the same
administration.