R21xx-HP FlexFabric 11900 Layer 3 IP Routing Configuration Guide

313
Configuration prerequisites
Before you configure OSPFv3 network types, enable OSPFv3.
Configuring the OSPFv3 network type for an interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure a network type for
the OSPFv3 interface.
ospfv3 network-type { broadcast |
nbma | p2mp [ unicast ] | p2p }
[ instance instance-id ]
By default, the network type of an
interface depends on the media type
of the interface.
Configuring an NBMA or P2MP neighbor
For NBMA and P2MP interfaces (only when in unicast mode), you must specify the link-local IP addresses
of their neighbors because these interfaces cannot find neighbors through broadcasting hello packets.
For NBMA interfaces, you can also specify DR priorities for neighbors.
To configure an NBMA or P2MP (unicast) neighbor and its DR priority:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Specify an NBMA or P2MP
(unicast) neighbor and its DR
priority.
ospfv3 peer ipv6-address [ cost
value | dr-priority dr-priority ]
[ instance instance-id ]
By default, no link-local
address is specified for the
neighbor interface.
Configuring OSPFv3 route control
Configuration prerequisites
Before you configure OSPFv3 route control, complete the following tasks:
• Configure IPv6 addresses for interfaces to ensure IPv6 connectivity between neighboring nodes.
• Enable OSPFv3.