R21xx-HP FlexFabric 11900 Layer 3 IP Routing Configuration Guide

352
To configure IPv6 interface PBR:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view. interface interface-type interface-number N/A
3. Apply an IPv6
policy to the
interface.
ipv6 policy-based-route policy-name
By default, no IPv6 policy is
applied to the interface.
Displaying and maintaining IPv6 PBR
Execute display commands in any view and reset commands in user view.
Task Command
Display IPv6 PBR policy information. display ipv6 policy-based-route [ policy policy-name ]
Display IPv6 PBR configuration. display ipv6 policy-based-route setup
Display IPv6 interface PBR configuration and
statistics (in standalone mode).
display ipv6 policy-based-route interface interface-type
interface-number [ slot slot-number ]
Display IPv6 interface PBR configuration and
statistics (in IRF mode).
display ipv6 policy-based-route interface interface-type
interface-number [ chassis chassis-number slot slot-number ]
Clear IPv6 PBR statistics. reset ipv6 policy-based-route statistics [ policy policy-name ]
Packet type-based IPv6 interface PBR configuration
example
Network requirements
As shown in Figure 83, configure IPv6 PBR on Switch A to forward all TCP packets received on
VLAN-interface 11 to the next hop 1::2. Switch A forwards other IPv6 packets according to the routing
table.