R21xx-HP FlexFabric 11900 Layer 3 IP Routing Configuration Guide

360
Ste
p
Command Remarks
3. Match routes whose destination,
next hop, or source matches a
specified prefix list.
• Match IPv4 routes whose
destination, next hop, or source
matches the IPv4 prefix list:
if-match ip { address | next-hop |
route-source } { acl acl-number |
prefix-list prefix-list-name }
• Match IPv6 routes whose
destination, next hop, or source
matches the IPv6 prefix list:
if-match ipv6 { address |
next-hop | route-source } { acl
acl6-number | prefix-list
prefix-list-name }
By default, no IPv4 or IPv6
prefix list match criterion is
configured.
If the ACL used by an if-match
clause does not exist, the
clause is always met. If no
rules of the specified ACL are
matched or the match rules
are inactive, the clause is not
met.
The ACL specified in an
if-match clause must be a
non-VPN ACL.
4. Match BGP routes whose
AS_PATH attribute matches a
specified AS path list.
if-match as-path
as-path-number&<1-32>
By default, no AS path match
criterion is configured.
5. Match BGP routes whose
COMMUNITY attribute matches
a specified community list.
if-match community
{ { basic-community-list-number |
name comm-list-name }
[ whole-match ] |
adv-community-list-number }&<1-32>
By default, no COMMUNITY
match criterion is matched.
6. Match routes having the
specified cost.
if-match cost value
By default, no cost match
criterion is configured.
7. Match BGP routes whose
extended community attribute
matches a specified extended
community list.
if-match extcommunity
ext-comm-list-number&<1-32>
By default, no extended
community list match criterion
is configured.
8. Match routes having the
specified output interface.
if-match interface { interface-type
interface-number }&<1-16>
By default, no output interface
match criterion is configured.
This command is not
supported by BGP.
9. Match BGP routes having the
specified local preference.
if-match local-preference preference
By default, no local
preference is configured for
BGP routes.
10. Match routes having MPLS
labels.
if-match mpls-label
By default, no MPLS label
match criterion is configured.
11. Match routes having the
specified route type.
if-match route-type { external-type1 |
external-type1or2 | external-type2 |
internal | is-is-level-1 | is-is-level-2 |
nssa-external-type1 |
nssa-external-type1or2 |
nssa-external-type2 } *
By default, no route type
match criterion is configured.
12. Match RIP, OSPF, and IS-IS
routes having the specified tag
value.
if-match tag value
By default, no tag match
criterion is configured.