R21xx-HP FlexFabric 11900 Layer 3 IP Services Command Reference

257
tunnel bandwidth
Use tunnel bandwidth to set the bandwidth of a tunnel interface.
Use undo tunnel bandwidth to restore the default.
Syntax
tunnel bandwidth bandwidth-value
undo tunnel bandwidth
Default
The bandwidth of a tunnel interface is 64 kbps.
Views
Tunnel interface view
Predefined user roles
network-admin
Parameters
bandwidth-value: Specifies the bandwidth value of the tunnel interface in kbps, in the range of 1 to
10000000.
Usage guidelines
Set the tunnel interface bandwidth according to the actual bandwidth of the output interface. The
bandwidth set by the command is only used by dynamical routing protocols to calculate the cost of the
tunnel.
Examples
# Configure the bandwidth of the interface Tunnel 0 as 100 kbps.
<Sysname> system-view
[Sysname] interface tunnel 1 mode gre
[Sysname-Tunnel1] tunnel bandwidth 100
Related commands
display interface tunnel
tunnel dfbit enable
Use tunnel dfbit enable to set the Don't Fragment (DF) bit for tunneled packets.
Use undo tunnel dfbit enable to restore the default.
Syntax
tunnel dfbit enable
undo tunnel dfbit enable