R21xx-HP FlexFabric 11900 Layer 3 IP Services Configuration Guide

173
1.
A host in the IPv6 network sends an IPv6 packet to Device A at the tunnel source.
2. After determining according to the routing table that the packet needs to be forwarded through the
tunnel, Device A encapsulates the IPv6 packet with an IPv4 header and forwards it through the
physical interface of the tunnel. In the IPv4 header, the source IPv4 address is the IPv4 address of
the tunnel source, and the destination IPv4 address is the IPv4 address of the tunnel destination.
3. Upon receiving the packet, Device B de-encapsulates the packet.
4. If the destination address of the IPv6 packet is itself, Device B forwards it to the upper-layer
protocol. If not, Device B forwards it according to the routing table.
Tunnel modes
IPv6 over IPv4 tunnels include manually configured tunnels and automatic tunnels, depending on how
the IPv4 address of the tunnel destination is acquired.
• Manually configured tunnel—The destination IPv4 address of the tunnel cannot be automatically
acquired from the destination IPv6 address of an IPv6 packet at the tunnel source, and must be
manually configured.
• Automatic tunnel—The destination IPv4 address of the tunnel can be automatically acquired from
the destination IPv6 address (with an IPv4 address embedded) of an IPv6 packet at the tunnel
source.
According to the way an IPv6 packet is encapsulated, IPv6 over IPv4 tunnels are divided into the
following modes.
Table 10 IPv6 over IPv4 tunnel modes and key parameters
Tunnel type Tunnel mode
Tunnel source/destination
address
Destination IPv6
address format
Manually
configured tunnel
IPv6 over IPv4 manual
tunneling
The source and destination IPv4
addresses are manually
configured.
Ordinary IPv6 address
Automatic tunnel
6to4 tunneling
The source IPv4 address is
manually configured. The
destination IPv4 address is
automatically obtained.
6to4 address, in the
format of
2002:IPv4-destination-
address::/48, where
the
IPv4-destination-addres
s is the IPv4 address of
the tunnel destination.
ISATAP tunneling
The source IPv4 address is
manually configured. The
destination IPv4 address is
automatically obtained.
ISATAP address, in the
format of
Prefix:0:5EFE:IPv4-dest
ination-address/64
where the
IPv4-destination-addres
s is the IPv4 address of
the tunnel destination.